Pneumatics section

Directional control valves are used in pneumatic systems to direct or stop the flow of compressed air or oil to their appliances. They are probably the most used elements in pneumatic systems and can be used for example to actuate a cylinder, a larger industrial valve, or air tools. The valves can have two or more ports and fulfil various circuit functions. The function and behaviour of the valve can be indicated by a symbol. The symbol however doesn't explain the construction of the valve. Directional control valves can be actuated by different means, such as manual actuation or solenoid actuation. This article focuses on the different directional solenoid valves for pneumatic systems.
Quick Exhaust Valve
( Customer review)
Quick Exhaust Valves facilitate accelerated movement of the cylinder rod or valve actuator. A Quick Exhaust Valve is a 3/2 valve with an extra large exhaust orifice designed to fit directly onto the cylinder port connection.The function of a quick-release valve is to rapidly exhaust air from the controlled device. It is normally located adjacent to the controlled device, rather than requiring exhaust air to return and exhaust through the control valve. This decreases release time.
“Y” Type Angle Valve
( Customer review)
Y Type Angle Valve is very ideal for On-Off pneumatic regulation of the media such as air, water, steam, Oil etc. These are accessible in screwed or flanged ends connections designed by our experts and are composed of the finest quality basic materials. It uses a linear motion to move a closure member into and out of a seating surface. Angle valves are commonly used in boiler feed water and heater drain service and in piping schemes where space is at a premium and the valve can also serve as an elbow.
Pneumatic Auto Drain Valve
( Customer review)
A drain valve performs the critical function of allowing excess water vapour to escape into the atmosphere. The removal of condensation helps prevent the formation of corrosion that will eventually damage the compressor and shorten its lifespan.Some compressed air auto drains work on the float principal. As water and contamination accumulates in the bottom of the bowl, it will ultimately lift a float. The compressed air, under pressure in the bowl, will then vent to atmosphere through the drain opening, blowing the water and debris from the bowl as it does.
Air filter regulator is basically combination of air filter and air regulator. It filters the air and regulate.
Pneumatic Air Filter
( Customer review)
Compressed air is hot, wet, and dirty. Air filters clean contaminants from compressed air to insure proper, consistent operation and to reduce wear on mechanical parts.
Pneumatic Air Regulators
( Customer review)
Each pneumatic system has an optimal operating pressure and exceeding this pressure results in excessive wear and wastes compressed air. Regulators are designed to maintain a consistent prescribed outlet pressure regardless of the inlet pressure and also maintain a consistent pressure regardless of flow rate requirements. The precision needed to maintain the regulation and flow requirements determines the type and cost of regulators needed.
FRL Unit
( Customer review)
FRL UNIT is basically combination of Air filter, Air regulator an Air lubricator.
Solenoid Valve Coils
( Customer review)
Pneumatic cylinder accessories are used for mounting or for coupling it to a load. Some accessories are included in ISO 6432 and ISO 15552, so they can be interchanged with any brand. However, they can be used with non-ISO cylinders if the mounting specifications match. Mounting accessories will affect system performance, reliability, and overall design. Based on the intended function and system requirements, the correct mounting accessories can be selected.
Pneumatic Quick Coupler
( Customer review)
Quick disconnect fittings (abbreviated as “QDCs” or “QDs”) are used to provide fast and easy connection and disconnection of fluid lines. These fittings are also known as quick connects or quick release couplings. They often are used to replace fitting connections which require tools to assemble and disassemble.
Pneumatic Air Gun
( Customer review)
Air blow guns are a staple of many workplaces, including mechanic shops, assembly lines, and even construction sites. Because they perform essential tasks, ranging from inflating tires to cleaning surfaces, it’s important to choose a high-quality, durable air blow gun that you can rely on every day.