Foot Pedal Valves are used to operate Pneumatic Cylinders. In the absence of electrical supply, manually operated valves such as Foot Pedal Valves are used. The functioning is the same, however, the solenoid coil is replaced by a foot pedal, which controls the movement of the spool inside the valve, thereby allowing the air to pass.
Solenoid Direct acting valves
(0 Customer reviews)In a direct acting solenoid valve, a coil magnetically opens the valve in a direct action, lifting the shaft and the seat of the valve without depending on outside pressure.
Category: Uncategorized
Related products
Aluminum P.U fittings and Oil window
( Customer review)Aadarsh Hydropneumatics is a notable exporter and supplier of engineering products. Authorized and Specialist in Aluminium P.U fittings and Oil window
Aluminium P.U fittings and Oil window are used in surroundings where there is involvement of high temperatures or corrosive fluids. Aluminium P.U fittings and Oil window are also procurable in materials with / without support to be used in standard applications. When the fitting is under pressure, these fittings include a positive tube seal which permits the utilization of polyurethane tubing.Aluminium oil glass windows are long-lasting and corrosion resistant which are frequently used in those applications where consistent and faultless signals of the oil level are essential.Regulators
( Customer review)
Each pneumatic system has an optimal operating pressure and exceeding this pressure results in excessive wear and wastes compressed air. Regulators are designed to maintain a consistent prescribed outlet pressure regardless of the inlet pressure and also maintain a consistent pressure regardless of flow rate requirements. The precision needed to maintain the regulation and flow requirements determines the type and cost of regulators needed.
Solenoid Pilot operated valves
( Customer review)
In pilot operated valves, the plunger opens up the pilot opening while built-up pressure causes the valve to open and close.
Although piloted valves require less electrical energy to operate, they usually need to maintain full power in order to remain in an open state, and they perform at a slower rate than direct acting solenoids. Direct acting solenoid valves only need full power when opening the valve, as they can hold their open position even when operating on low power.